SOUND SYSTEM Yamaha / DBR 15

System Type : 2-way, Bi-amp Powered Speaker, Bass-reflex Type Frequency Range (-10dB) 50 Hz””20 kHz

Coverage AngleH90 x V60 Constant Directivity Horn , Crossover TypeFIR-X Tuning (Linear Phase FIR Filter), Crossover Frequency2.1 kHz, Measured Maximum SPL (Peak), IEC [email protected] dB SPL

Transducer DBR15 LF , Diameter15″ Cone , Voice coil 2.5″ Magnet Ferrite HF
Diaphragm1.4″ Type 1″ Throat Compression Driver Magnet Ferrite

Material, Color Plastic, Black, Floor Monitor Angle 50 Symmetrical

Dimensions (WxHxD, with rubber feet) 455 x 700 x 378 mm (17.9″ x 27.6″ x 14.9″)
Net Weight 19.3 kg (42.6 lbs), Handles Side x 2, Pole Socket 35mm
Rigging Points Bottom x 2, Rear x 1 (Fit for M8 x 15mm Eyebolts)

Amplifier Type Class-D, Power Rating *1, Dynamic 1000 W (LF: 800 W, HF: 200 W)
Continuous465 W (LF: 400 W, HF: 65 W)

Cooling Fan Cooling, 4 , peeds. , AD/DA 24bit 48kHz, Sampling, HPF/LPF OFF, 100Hz, 120Hz, , 24dB/Oct. HPF, DSP Preset, D-CONTOUR: FOH/MAIN, MONITOR, OFF, Protection: SpeakerClip Limiting, Integral Power Protection, DC-fault, Amplifier Thermal, Output Over Current, Power: SupplyThermal, Output Over Voltage, Output Over Current

Connectors Input1: Combo x1, Input2: Combo x1, RCA PIN x2 (Unbalanced)
Output Output: XLR3-32 x1 (CH1 Parallel Through or CH1+CH2 Mix) , Input Impedance INPUT1 (XLR, Phone): 3 k, INPUT2 (XLR, Phone, RCA Pin): 10 k, Input Sensitivity (LEVEL: Maximum) INPUT1: LINE: 0 dBu, MIC: -32 dBu, INPUT2: 0 dBu, Input Sensitivity (LEVEL: Center) INPUT1: LINE: +10 dBu, MIC: -22 dBu, INPUT2: +10 dBu
Maximum Input Level INPUT1: LINE: +24 dBu, MIC: -8 dBu, INPUT2: +24 dBu

Controls LEVEL x2, LINE/MIC, HPF, D-CONTOUR, THRU/MIX, POWER
Idle Power Consumption 18 W 1/8 Power Consumption 74 W
Power Requirements 100 V, 100””120V, 220””240 V, 110/127/220 V (Brazil), 50/60 Hz